flight sim MFD button array controller

por Robdor

Ficheiros imprimíveis (5)

  • stl

    MFD_Face_R1.stl

    839 Ko · 1 191 descargas

    Descarregar
  • stl

    MFD_Face_R1_mirror.stl

    724 Ko · 1 192 descargas

    Descarregar
  • stl

    PushButtonSwitchHat1.stl

    392 Ko · 1 197 descargas

    Descarregar
  • stl

    PushButtonSwitchHat2.stl

    419 Ko · 1 191 descargas

    Descarregar
  • stl

    MFDBackCover.stl

    89 Ko · 1 129 descargas

    Descarregar

Descrição

Setup Tasks:
the arduinos show up with the same USB name and device ID. This can cause some issues if you are using more than one panel. I've had DCS switch back and forth depending on how the game loads up the panels. The comment from Dakor91 on March 4th, 2017 in the following link provides a solution by editing the boards file and inputing in a unique VID, PID, and device name: https://github.com/MHeironimus/ArduinoJoystickLibrary/issues/14

additional resources:
Arduino due boards.txt location (it's hiding in users/.../appdata/...: https://stackoverflow.com/questions/35799214/location-of-boards-txt-for-an-arduino-due-sam-board
pid.codes: http://pid.codes/

Materials:
Push button switch, 1P1T, momentary (qty 20)
Toggle switch, 1P2T, momentary (qty 5)
Rotary switch, 1P12T, (qty 2) [only using 5 pins, switch has locking ring to prevent rotation past desired setting]
Encoder w/ push button KY-040 (qty 4)
Arduino Due (qty 1)
metric poop ton of stranded wire

Code:
code works but I haven't gone back to clean up the comments. may have some out dated comments from when I was using a diode matrix to add more push buttons.