Raspberry Pi Snug Case
von Esquilo
Druckbare Dateien (5)
-
stlPi_Snug_Case_Top_Closed.stl
147 Ko · 9 703 Downloads
-
stlPi_Snug_Case_Bottom.stl
363 Ko · 10 516 Downloads
-
stlPi_Snug_Case_Top_Slots.stl
368 Ko · 10 263 Downloads
-
stlPi_Snug_Case_Top.stl
150 Ko · 9 701 Downloads
-
stlPi_Snug_Case_Top_Closed_Slots.stl
365 Ko · 9 782 Downloads
Beschreibung
A snug fitting case for the Raspberry Pi with screw board mounts and a snap top. This case is designed to fit the Raspberry Pi Model B+, Pi 2 Model B, and Pi 3 Model B. HATs may be installed over the top of the case. The top comes in four versions - cooling slots and connector openings, cooling slots only, connector openings only, and with no slots or openings.
There are two holes on both sides of the front to view the two LEDs on the Pi board since the Pi 3 has the LEDs on the opposite side as the other models. The micro SD is easily removed with a curved card entry on the bottom of the case.
The standoffs for the Pi board are designed for #2 x 1/4" thread rolling screws.
For the Arduino Uno, see the Arduino Uno Snug Case.
For the Arduino Mega, see the Arduino Mega Snug Case.