Pendulum waves
von inmortalkaktus
Druckbare Dateien (6)
-
stl3_rod_union_x2.stl
37 Ko · 1 052 Downloads
-
stl2_rod_union_x4.stl
47 Ko · 1 046 Downloads
-
stlbig_rod_x1.stl
7 Ko · 1 062 Downloads
-
stlsimple_rod_x6.stl
5 Ko · 1 054 Downloads
-
stlsimple_hook_parallel.stl
55 Ko · 1 062 Downloads
-
stldouble_hook_perpendicular.stl
79 Ko · 1 056 Downloads
Beschreibung
Introduction
You will need as hooks as nuts you want to use.
Probably, you will want to make larger the big rod, you just have to extrude the face (in my case, it has the maximum size that my 3D printer allows me).
Assembly
Once we have everything printed, we will need to do some calcs to get the respective size of each thread. We will use the equation I've attached down.
First, we will have to calculate the constant "k", so, we are going to put as "L" the maximum height we want, and we are going to use "1" as "n", because is the first nut.
Now that we have the constant, we simply replace it with its value, and to get the following values of the nut's height we will replace the "n" by the next nut number until we reach the amount of nuts we are going to put.
Now, I wish you much patience to give you the exact measurement with the threads (you have to measure it from the center of the nut to the top of the hook)
https://www.youtube.com/watch?v=CZf5cRKqKvo
https://www.youtube.com/watch?v=Pha6WBY8p3w