Drone Timer (PIDFlight ESP32)
von eried
Druckbare Dateien (4)
-
stlcase_switch_internal.stl
3 Ko · 221 Downloads
-
stl
case_switch_slider.stl
275 Ko · 229 Downloads
-
stl
case_down.stl
126 Ko · 225 Downloads
-
stl
case_up.stl
358 Ko · 229 Downloads
Beschreibung
It is a timer for your fpv drones and whoops.
How does it work?It uses the video transmission signal to estimate the position of the drone, so no new hardware needed on the drones. You calibrate the signal in a certain "gate" and then track your lap times with it.
Make one
Print the case and order the parts. You have to superglue the switch slider parts. The two teardrop-shaped holes need to be filled with some translucent material. They difuse the ESP32 T8 leds, I used a 3d pen and translucent PLA as you can see in one of the photos.
Check https://github.com/eried/pidflight-lap-firmware for more details.
Parts
- ESP32 TTGO T8 https://s.click.aliexpress.com/e/_d6sfNUb
- RX5808 https://s.click.aliexpress.com/e/_dUaM1rh
- 2x 4.7K resistors
- Small battery (optional) i.e.: https://aliexpi.com/ZSsn
- Buzzer (optional) https://s.click.aliexpress.com/e/_d75AAWT
Software
It uses PIDFlight firmware and app (available for several platforms). I adapted the firmware to run on the ESP32. In the future it could work standalone, using BT, Wifi and the SD capabilities of the microcontroller.