Eureka Mignon Single Dose Set

The model was build from ground up but I took the design ideas from rmanalan - hence the remix.

This set consists of 3 items:

1. Bean chute: this is the main chute to replace the stock standard Eureka Mignon chute
2. Bean Lid: this is used to put on in the chute while the bean is grinding as it reaches towards the last portion to help prevent the bean pop-corning/jumping around
3. Bellow: this is the air puffer to push the final bits of grounds out of the grinder

The Bean chute and lid I printed using PLA+ 30% infill. Print the lid with the round top at the bottom. Print the chute upside down - the round mouth opening at the bottom - you don't need support

The bellow i printed using TPU, again print it with the large round top at the bottom. No support needed.