Computer Speaker Stand
von KungFu_Toe
Druckbare Dateien (4)
-
stlComputer_Speaker_Stands.stl
303 Ko · 117 Downloads
-
stlSpeaker_Stand_Post.stl
76 Ko · 108 Downloads
-
stlSpeaker_Stand_Top.stl
177 Ko · 110 Downloads
-
stlSpeaker_Stand_Base.stl
226 Ko · 108 Downloads
Beschreibung
Computer Speaker Stand designed for 5 inch speakers. Raises speakers about 8 inches to bring tweeters to ear level. Three files are included (base, top, and post). The post will need to be printed four times. I've also included a mesh of the entire base for visual inspection. I don't believe the full base is printable. This design is an attempt to decouple the speaker from the desk by crossing the posts diagonally (YMMV). I'm also using 4% fill and pause the printer just before the top layers to (very carefully) fill the base with fine sand.
The gaps between the posts and mounting holes are 0.4mm. This is to allow enough flexibility to flex the posts inward, allowing them to fit in the holes. If gluing the stands together, I recommend not applying glue until the stand is fully assembled.