Snigel - stringer foam blaster
by vikingfabian
Printable files (11)
-
stlSnigel_blaster_body.stl
558 Ko · 1 026 downloads
-
stlSnigel_blaster_slider.stl
124 Ko · 997 downloads
-
stlSnigel_blaster_front.stl
89 Ko · 985 downloads
-
stlSnigel_blaster_sight.stl
8 Ko · 971 downloads
-
stlSnigel_blaster_trigger.stl
18 Ko · 984 downloads
-
stlSnigel_blaster_front_pin.stl
16 Ko · 992 downloads
-
stlSnigel_blaster_trigger_pin.stl
15 Ko · 984 downloads
-
stlExtra-Snigel_holster.stl
61 Ko · 934 downloads
-
stlExtra-Snigel_magazine.stl
161 Ko · 933 downloads
-
stlExtra-Snigel_holster_clip.stl
26 Ko · 928 downloads
-
stlExtra-Snigel_holster_clip_pin.stl
15 Ko · 926 downloads
Description
Nerf style blaster with matching holster and dart holder. Uses Elite half-length darts. Single bullet, string powered, top-loading.
All parts are printable except the string, use a 4-3mm bungee coord. The blaster use one of each model that are not marked with "extra"
The magazine and holster both use a clip and clip pin.
All parts are pre-oriented, and use friction fit, the back sight might need a drop of glue.
Snigel is Swedish for "snail".
BLASTER PRINT SETTINGS
I use the same settings for all parts:
- Outside in.
- 0.15mm lay height.
- 10% support with 70% angle.
- Brim (extra large on body).
- 3 wall lines.
HOLSTER & MAGAZINE PRINT SETTINGS
- 0.25mm lay height.
- A lange Brim.
NOTES
The darts will jam if they are too soft from long usage.
If you get jams, try loosen the string a bit.
Don't leave the darts in the holder for a long time.
EXTRA CREDITS
I took a lot of inspiration and design choices from these two creators:
LeedleDynamics
https://www.etsy.com/se-en/shop/LeedleDynamics
Xero1Tec Inc
https://ko-fi.com/xero1tec/