Blinky MultiMaterial
por MichelJ
Archivos imprimibles (8)
-
stlBody.stl
9.7 Mo · 653 descargas
-
stl
Body_PinLess.stl
9.7 Mo · 603 descargas
-
stl
EyeL_PinLess.stl
247 Ko · 608 descargas
-
stl
EyeR_PinLess.stl
253 Ko · 594 descargas
-
stl
EyeCenter_PinLess.stl
307 Ko · 593 descargas
-
stl
EyeCenter.stl
354 Ko · 614 descargas
-
stl
EyeL.stl
291 Ko · 607 descargas
-
stl
EyeR.stl
302 Ko · 605 descargas
Descripción
This is a remix to print Blinky in 2 colors. I made 2 version: with and without alignment pins. This model is very small and the pins are useless when you print it too small. In the picture you have 2 sizes: 100% and 125% and in both cases the pins didn't fit. So unless you're printing it very big don't waste your time with the pinned version! In fact I don't think they are needed at all!
Use "Align To Build Plate" in Cura to rotate the eyes.
Left and right are from Blinky'S point of view ;)
Good luck gluing the eyes without gluing your fingers! Don't worry, it's doable... just don't put too much glue!