Push Block
por theMachinista
Archivos imprimibles (17)
-
stlMain_Body.stl
120 Ko · 1 530 descargas
-
stl
Handle_Heatsert.stl
992 Ko · 1 498 descargas
-
stlHandle_2.stl
190 Ko · 1 334 descargas
-
stl
12mm_Side.stl
57 Ko · 1 465 descargas
-
stl
6mm_Side.stl
57 Ko · 1 463 descargas
-
stl
Middle_Leg.stl
21 Ko · 1 459 descargas
-
stl
Tail.stl
1 Ko · 1 449 descargas
-
stl
Leg_Extension.stl
69 Ko · 1 462 descargas
-
stl
Stabilizing_Leg.stl
462 Ko · 1 468 descargas
-
stlTall_Knob.stl
887 Ko · 1 315 descargas
-
stlShort_Knob.stl
878 Ko · 1 312 descargas
-
stl
Knob_Screw_Plug.stl
30 Ko · 1 450 descargas
-
stl
Knob_Nut_Plug.stl
46 Ko · 1 446 descargas
-
stl
Tee_Nut.stl
29 Ko · 1 455 descargas
-
stlStabilizing_Plate_Left.stl
45 Ko · 782 descargas
-
stlStabilizing_Plate_Right.stl
45 Ko · 779 descargas
-
stlStabilizing_Plate.stl
45 Ko · 785 descargas
Descripción
This is a remix of Trobinou's saw/router table push block with the holes in the main body, Side Plates, and handles resized to accept heat set thread inserts.
You'll need 12 m4 inserts to press into the main body and side plates, and two m5 inserts to press into the bottom of the handle.
Other changes I've made are extending the tee track through the side plates to make it easier to install extra tee plates for other accessories. I've also added slots in the edges of the stabilization plate. Made a reversible handle and middle leg with tails on either sid, and created a side plate extension.
The basic dimensions and screw holes are located to make everything interchangeable with Trobinou's original design.
I've also included my f3d file for anyone else who wishes to change or add to the functionality of this handy tool.
05/19/21 Edited design with three different stabilizing plates. One plain, and one each with the hook on the left and right for pushing against either side of the saw fence.