Xbox One Controller Car Conversion Kit
por JnBean
Archivos imprimibles (0)
Descripción
Update V0.98: 6 Part steering wheel - maximum sized to fit on almost any std sized printer
Update V0.96: Finally the new self centering 900 degree steering is updated!
Update V0.82: Changed the HPatternHousing for a better clearance when shifted in fifth and sixth gear.
Update: Incase you already downloaded the base plate - I had forgot one hole for the front left leg of the shifterhousing... Sorry! Now its updated and uploaded! Left baseplate is added aswell.
Xbox One Car Conversion KitThis is a conversion kit for Xbox One Controllers. It enables you to get a steering wheel, brake and throttle pedal and a full 6+R H-Pattern shifter with just the prints and a few screws here and there.
Keep in mind this thing is work in progress - I will updating some of those parts for better printing possibility and better usability.
Some parts like the base, the arms and the xbox-holder-clamps are derived from the Snap-on XBOX HOTAS from akaki - mate, that thing is just amazing, thank you for that design!
!!! To be able to shift with the right thumbstick you need my software that translates the shifts on the Xbox Controller to the gears ingame. !!!
You can get the software over on my patreon-site:
https://www.patreon.com/JnBean
For the current design (V0.8) you need the following extras:
For the Controller-Kit:
3x M3x12
Small standard-kitchen-rubberband
(I use some clamps to clamp the bases down to my table as you can see in the video. In further updates I will try to eliminate the need of those clamps)
For the pedals:
Thin fishing line (or any line you can get your hands on) to connect the pedals with the throttle and brake levers.
4x M3x12
4x M4 screws or 4 mm wood screws to screw the throttle and brake holder on a wooden plate or smthn (I used cardboard and M4 screws with a nut on the other side.)
Throttle_Brake_Lever needs to be printed twice, every part needs to be printed once.