PCB Etching Tank

This is thank is useful to etch PCBs, I made it using PLAel .
To ease the filling of the tank, a special funnel is provided.

Dimensions are about 220mm wide x 220mm height.
If your 3D printer doesen't manage such vertical dimension , just stop printing at the maximum height you can reach..

To improve sealing i followed some advices on the internet:

• printed at higher temperature than usual (I use 205° degree) to impreve slice adhesion
• slightly overextrude
• used low speed
  At the end of my printing I had no leaks' problem at all.

If you have leaks, you can still cover inside using sealing paint, wax, liquid silicone etc..

if you want some other ideas about DIY Printed parts here is my site:
http://agalavotti.altervista.org/TubeGears/Tube_3d_printed_parts.html

Share & EnjoY ;)