basic scale wind turbine
door Svenergy
Printbare bestanden (7)
-
stlmain2_300mm.STL
21 Ko · 14 108 downloads
-
stlmain1_250mm.STL
85 Ko · 14 267 downloads
-
stlhead_250mm.STL
76 Ko · 14 160 downloads
-
stlhead_300mm.STL
237 Ko · 14 189 downloads
-
stlRotor_blade_300mm.STL
342 Ko · 14 521 downloads
-
stlmain1_300mm.STL
85 Ko · 14 101 downloads
-
stlRotor_blade_250mm.STL
343 Ko · 14 496 downloads
Beschrijving
this is a simple scale wind turbind model, which was originally designed to fit onto a model railway scenario. There are two versions: one is approx 300mm high and fit to 1:120 scale. The other one is approx. 250mm high and fit to 1:160 scale.
The head and rotor of both versions are prepared to carry a small geared dc motor with 3mm shaft (see pictures). My personal ideal gear ratio is 1:298, then it spins quite slowly.
The 300mm version is made out of two main parts due to limited printing height of my printer. All parts are just plug and play with slight press fit.
I´ve printd the rotor just flat on the build plate with little support, whereas the surface failures are not so important.