Spinning Coaster
door muzz64
Printbare bestanden (6)
-
stl90mm_base.stl
463 Ko · 5 310 downloads
-
stl80mm_base.stl
396 Ko · 5 345 downloads
-
stl100mm_base.stl
466 Ko · 5 406 downloads
-
stl100mm_top.stl
1.5 Mo · 5 406 downloads
-
stl80mm_top.stl
1.4 Mo · 5 346 downloads
-
stl90mm_top.stl
1.5 Mo · 5 271 downloads
Beschrijving
Spinning Coasters are just for fun... but great for people who like to fidget, displaying (both sides of) scale models and lots more...
Well printed Spinning Coasters should spin easily / freely. The idea is not to spin them fast (like a fidget spinner) but slowly rotate... just for fun. However, they are great as a display stand for your favourite 3D prints, and scale models.
Good build plate adhesion and accurate / precise printing is very important as flat, smooth and clean surfaces are required for smooth, low resistance spinning.
Each Spinning Coaster requires a base and top to be printed. The three sizes provided are 80 / 90 / 100mm in diameter. This range provides a coaster or stand to accommodate a wide range of 'things to spin' for display or just to fidget with. Just download the corresponding base and top then print...
This is an easy print on well set up machines. Spinning Coasters look great printed in any color... have fun with them!
No support is required. Make sure the contact surfaces are smooth and lubricated with a light silicone lubricant for best results.
Please refer to the images and print settings for additional information... and post images of your Spinning Coasters in use for other members to see!
Note: If you like this check out the rest of my practical and fun designs.