Pod Walker
door Ferjerez
Printbare bestanden (15)
-
stlhorizontal-axis.stl
416 Ko · 5 825 downloads
-
stlsphere-cabin.stl
7.6 Mo · 5 818 downloads
-
stlengine.stl
4.8 Mo · 5 798 downloads
-
stlpipe-1.stl
484 Ko · 5 791 downloads
-
stlpipe-2.stl
484 Ko · 5 785 downloads
-
stlR-leg-leg.stl
5.7 Mo · 5 809 downloads
-
stlL-leg-leg.stl
5.7 Mo · 5 787 downloads
-
stlleg-fingers.stl
1.4 Mo · 5 779 downloads
-
stlleg-foot.stl
2.6 Mo · 5 775 downloads
-
stlpilot-seat.stl
5.5 Mo · 5 788 downloads
-
stlpilot_rep.stl
13.1 Mo · 5 793 downloads
-
stlfull-color1.stl
18.9 Mo · 5 822 downloads
-
stlfull-color2.stl
19.9 Mo · 5 798 downloads
-
stlrobot.stl
52.5 Mo · 5 818 downloads
-
stlfull-plate.stl
38.9 Mo · 5 471 downloads
Beschrijving
Hi!
This is another robot/mecha/walker ready to print in parts then assembled.
Choose your favourite colour combo and print!!
Using the same pilot that i made for 'Tow Walker' (https://www.thingiverse.com/thing:2893106)
Tolerances around 0.2 mms so you shouldn't need sanding. If some parts comes loose when assembling my best tip is using a bit of tape (see below) to made a strong fit.
I could print at 50% (in 5 hours) and it works!!
Include a full-plate.stl with all the parts ready to print-in-place (fits in a 18x18 cms plate). Also there's 2 files 'full-color1.stl and full-color2.stl with the parts i've print in diferent colors
Just in case i included a 'robot.stl' with the full figure in a piece.
NO SUPPORTS NEEDED!!! :D
Hope you like it.
Have fun!!