Tesla Model S console insert (pre-refresh)

This is a centre console for a Model S designed for my needs - might not fit yours :)
The insert contains a large section for sunglasses, a section to hold gum, a "roll top" section for "stuff", a place to drop loose change and a place at the very rear for charging cards.

When you print the main box, you can slide the rolltop in (when printed in PETG its flexible enough), the fit the coin ramp in to seal the end.

No glue, or supports required - but you might need to play the rolltop in and out a few times to clear the channels.

I added some cushioning on the bottom of the large section to help protect sun glasses, used a little bit more down the side to wedge the insert in place.

In my car - the roll top section is printed in black and looks better for it, I've put in a red one for the photos so its easier to see.