Open Source STM32 Multimeter case
door embedblog
Printbare bestanden (8)
-
stlbutton_round_attachment.STL
20 Ko · 693 downloads
-
stl
button_attachment.STL
9 Ko · 690 downloads
-
stl
distancer.STL
13 Ko · 691 downloads
-
stl
top.STL
160 Ko · 694 downloads
-
stl
bottom_leg.STL
27 Ko · 690 downloads
-
stl
body.STL
69 Ko · 695 downloads
-
stl
slide_attachment.STL
3 Ko · 689 downloads
-
stl
bottom.STL
129 Ko · 689 downloads
Beschrijving
This is a 3D printed case for my Open Source STM32 Multimeter. It houses the board, provides a simple leg (to enable you to tilt the whole device) and also you can put on it stickers with button/banana jack functions (because you don't want to mistake the voltage and current measurement holes, trust me).
The board and features of the multimeter are further described here.
For the assembly you will need some M2 screws, washers and brass M2 insert nuts. Also I recommend that you stick rubber feet onto the designated spots, see the photos. Or alternatively, print rubber feet out of something like NinjaFlex.
You can also find SolidWorks files on the Github repo, so feel free to modify it however you want.