Lightburn Camera Mount
door Narosenberg
Printbare bestanden (12)
-
stlKnob.STL
780 Ko · 6 674 downloads
-
stl
Bracket.STL
250 Ko · 6 614 downloads
-
stl
Cover.STL
314 Ko · 6 570 downloads
-
stl
Board_mount.STL
166 Ko · 6 690 downloads
-
3mf
Bracket.3MF
19 Ko · 5 469 downloads
-
3mf
Cover.3MF
31 Ko · 5 438 downloads
-
3mf
Knob.3MF
79 Ko · 5 403 downloads
-
3mf
Board_mount.3MF
14 Ko · 5 428 downloads
-
step
Board_mount.STEP
101 Ko · 3 703 downloads
-
step
Cover.STEP
175 Ko · 3 678 downloads
-
step
Bracket.STEP
91 Ko · 3 662 downloads
-
step
Knob.STEP
164 Ko · 3 643 downloads
Beschrijving
This is designed specifically for the camera that Lightburn sells for use in Laser Engravers/Cutters. It mounts to the underside of the lid, pointing down at the bed. The swivel allows the camera to be adjusted for angle and then locked.
M5 x 20mm Low Profile screws are best, but others can be substituted. The nuts are either locking or not. Captive nuts are used throughout. The Cover snaps into place.
The unit is open on one end to permit the wires to exit. The camera is mounted to the bracket with 3M VHB tape or equivalent, and the entire assembly is mounted to the Laser door also with the 3M tape.
CAD models available on request.