Sunlu PLA empty stackable & rotatable spool storage container

I made an easy to print storage container from old plastic Sunlu spools.
There are different sizes spools so look out for these measurements.

• Diameter 195mm
• Inside Height 50mm

Just close the spool and slide the containter between the spool.
Use the bolt after each compartment to stack them.

Print Details:

• Both parts are constructed to be completely support FREE.

Container:

• Wall loops = 4
• Top Shell Layers = 5
  I advise using these settings as The ring where the container turns on might break if it isn't reïnforced.
  The wall loops make sure that part is a 100% Infill and the top shell layer is there for the rupture of the complete cilinder.

Rotating Knob:

• Nothing of special value

1/8/2025
Added The editable tag