Switch enclosure for handlebars
por 0utsider
Ficheiros imprimíveis (3)
-
stlBarEncClamp.stl
135 Ko · 2 527 descargas
-
stlBarEncLid.stl
173 Ko · 2 505 descargas
-
stlBarEncBody.stl
230 Ko · 2 549 descargas
Descrição
A small bar mounted switch enclosure. It's a tight fit for the switches but I wanted to keep the size to a minimum.
M3 countersunks screw straight into the ABS as do the M4 screws of the bar clamp. Do not over tighten.
Designed for 22mm Ø bars, use a thin piece of rubber or foam between the bar and body/clamp. I used an old (unused) puncture repair patch.