LACK table printer hinge/ latch
por Reciprocation_Props
Ficheiros imprimíveis (3)
-
stlhinge_part_2_v2.STL
600 Ko · 1 246 descargas
-
stlhinge_part_1_v2.STL
810 Ko · 1 211 descargas
-
stlhinge_pin_v1.STL
37.5 Mo · 1 244 descargas
Descrição
This is a latch/ hinge for converting a Ikea Lack table into a 3d printer enclosure, just print 3-4 of each part and install 2 as hinges and the other 1 or 2 as latches. There is a cut out on the back of one side meant for foamcore/ acrylic/ polybarbonate to be attached. The holes in the hinge plates are .125in across and the cut out is also .125in deep. It took about 5.5 hours to print all of the parts at .2mm.