Thin Footswitch
por PacificBlue
Ficheiros imprimíveis (3)
-
stlThin_Footswitch_Bottom.stl
9 Ko · 1 053 descargas
-
stlThin_Footswitch_Center.stl
50 Ko · 1 085 descargas
-
stlThin_Footswitch_Top.stl
11 Ko · 1 054 descargas
Descrição
Thin Footswitch is designed to trigger the scary props in your front yard on Halloween when Trick or Treat'ers pass by. You'll need some aluminum foil, a bit of double-stick tape, and the connector off the other end of the wire from the "Try Me" button on the box the animated prop came in. It's 144mm square & 5mm thin, small enough to print on most 3D printers. Print it half-black to hide it, half-bright so you can't miss it, or print one side in flourescent filament so it glows under blacklight, use your imagination!