Model Rocket Ignition Box
por RotorGator
Ficheiros imprimíveis (2)
-
stlBox_Lid.stl
47 Ko · 2 299 descargas
-
stlLaunch_Ignition_Box.stl
142 Ko · 2 343 descargas
Descrição
This launch ignition box is for model rockets. It prints assembled and in place with no supports. For use with one 9v battery. The case has a freely moving switch cover to protect from accidental discharge. The case has a sliding panel to ease access and change out the battery.
You will need a 9v battery, momentary switch (normally open), 9v battery clip, and a length of bell wire (or similar). The hole for the momentary switch is 7mm in diameter. Modify or drill out to accommodate for larger/smaller switch you may purchase. All parts, except the battery, should run you less than a couple dollars.