Raspberry Pi4 Case
por olialb
Ficheiros imprimíveis (4)
-
stlMod_bottom_side_vent_7mm_Antenna_hole.stl
3.1 Mo · 3 439 descargas
-
stl
Mod_top.stl
1.4 Mo · 3 452 descargas
-
stl
Mod_bottom_side_vent.stl
3 Mo · 3 585 descargas
-
stl
Mod_top_fan.stl
1.7 Mo · 3 243 descargas
Descrição
Based on the great design of anjanathisal I created this case with the following changes:
- More venting holes on top bottom and sides to allow more air flow
- Holes for screws to fix the case that its not accidentally opening
- Add screw cylinders to case top to fix the PCB inside
- Make the case 2mm higher to give some space to add ons inside
I have here two variants. One has an additional hole for a antenna connector. I use it for my HM-MOD-RPI-PCB ELV module. Its for my openhab homematic integration.
Update 2019-12-05:
The temperature in the passive cooled housing (using my openHAB configuration) was still over 60 degrees Celsius. I decided to add a top cover with fan... Now its arround 42 degrees with the fan connected to 3.3V!