Inkbird Temperature Controller Case

There are a few other Inkbird cases on Thingiverse, but I designed this one to fit my needs.

1 - It fits in a 120mm build area. So I can print it on my Monoprice Mini.
2 - It has spots for two panel mount outlets, so I can use it for both heating (sous-vide) and cooling (homebrewing).
3 - It's designed so that water can't get in easily. The vent holes are angled down, and the top piece overlaps the bottom.
4 - It has a fused power inlet, just in case.
5 - It doesn't require any hardware to assemble (sort of).
6 - It's designed to be easy to print.
7 - It has a thing to wrap the probe around when not in use.
8 - It will use up some of this ugly yellow filament I have laying around.

You'll only need the following parts -

Inkbird ITC-2000
Power Inlet
Two screws from your junk drawer for the inlet.
Surface mount plugs*