Ember Celica
par panikjoker
Fichiers imprimables (4)
-
stlpart2_print_ready.stl
19 Ko · 1 417 téléchargements
-
stlslider_printable_parts.stl
49 Ko · 1 421 téléchargements
-
stlprint_ready.stl
100 Ko · 1 406 téléchargements
-
stlpt5rev2.stl
685 Ko · 1 420 téléchargements
Description
I do not own the rights to RWBY, it is a Rooster Teeth production, and this is just a model of Yang's weapon the ember celica. remember if printing two of these that you should flip one of them in your slicer, otherwise they will both be for the same hand and that would be a huge waste of plastic. Please do not post this anywhere else or sell on the finished product for profit.
Also, yes I know that the design is a little rough and ready, i did it a while ago on tinkercad, I started one based more on the volume 4 stills a while ago but have been too busy to finish it.