Book Hide (small)
par Superbeasti
Fichiers imprimables (8)
-
stlBook_Hide_Small.stl
394 Ko · 5 541 téléchargements
-
stlPages_Small.stl
106 Ko · 5 515 téléchargements
-
stlUpper_Bolt.stl
93 Ko · 5 460 téléchargements
-
stlLower_Bolt.stl
93 Ko · 5 451 téléchargements
-
stlFifty_Shades_of_PLA.stl
1.1 Mo · 5 356 téléchargements
-
stlLord_of_the_PETGs.stl
989 Ko · 5 325 téléchargements
-
stlHarry_Printer_and_the_Goblet_of_ABS.stl
2 Mo · 5 328 téléchargements
-
stlTales_of_Princess_Saima.stl
957 Ko · 5 323 téléchargements
Description
A book-like container for all your things in need of a place to hide!
Create your own cover, either in the Customizer/editing the .scad file or just drawing a 54x70x1mm square, with 45 chamfered edge on the bottom and add your own mix in to it. All remixes/makes are welcomed!
Check out the large version here: https://www.thingiverse.com/thing:3593742
The book is assembled as follows:
- Separate the two sides of the Cover after printing.
- Remove the built in supports under the hinge and the lock pin.
- Clean all finish all parts.
- Do a test fit, make sure the Upper and Lower Pins go in all the way without resistance and spin freely, and the pages fit nicely.
- Insert the pins and glue the Pages to the back cover (this goes over the pins ends, locking them in place).
- Hide your things.
Check out my other designs here: https://www.thingiverse.com/Superbeasti/designs