Raspberry pi zero camera housing
par theswink
Fichiers imprimables (7)
-
stlshell-back.stl
57 Ko · 127 téléchargements
-
stl
mount-clip-clamp.stl
196 Ko · 111 téléchargements
-
stl
angle_bracket.stl
73 Ko · 106 téléchargements
-
3mf
raspi_zero_camera_housing_and_mount.3mf
166 Ko · 77 téléchargements
-
stl
shell-front.stl
124 Ko · 116 téléchargements
-
stl
ball_mount.stl
212 Ko · 104 téléchargements
-
stl
mount-clip-cam.stl
156 Ko · 102 téléchargements
Description
This is a raspi zero camera housing with wall / floor mount
and ball pivot.
it is made for the small camera modules.
do not use the sticky tape on the camera flex foil, everything fits snugly.
do not melt the pins inside the holes of the raspi.
the stud on the inside of the housing, goes on the Raspi logo. And On the Pi zero W, it goes next to the WIFI chip (the little mirror on the green thing with all the bird seed and the black square)
everything clicks together.
To strenghten the ball pivot, use an M3 x 12 flat head screw. Or a longer one if you wish to use the angle bracket.