Interlocking MTG Drawers
par lightningmb
Fichiers imprimables (10)
-
stlLand_MTG_Drawer.stl
93 Ko · 2 793 téléchargements
-
stl
Green-MTG-Drawer.stl
97 Ko · 3 044 téléchargements
-
stl
Blue-MTG-Drawer.stl
72 Ko · 3 039 téléchargements
-
stl
Black-MTG-Drawer.stl
96 Ko · 3 068 téléchargements
-
stl
Red-MTG-Drawer.stl
100 Ko · 3 036 téléchargements
-
stl
Colorless-MTG-Drawer.stl
77 Ko · 3 043 téléchargements
-
stl
White-MTG-Drawer.stl
112 Ko · 3 034 téléchargements
-
stl
Blank_MTG_Drawer.stl
63 Ko · 3 140 téléchargements
-
stl
Multicolor-MTG-Drawer.stl
271 Ko · 3 121 téléchargements
-
stl
MTG_Interlocking_Drawer.stl
34 Ko · 3 444 téléchargements
Description
This Is a remix of SenpaiCZ's Modular MTG Drower, I extended the size of the model to be just under the maximum size my printer could handle (174mm height). I also added a Colorless and Multicolor design, and included my version of the blank drawer.
Note: These drawers are designed for sleeveless cards.
I have printed the White, Blue, Green, and Red files so far, using the settings below, the outer drawer piece takes about 33 hours, and the inner drawer piece takes about 13 hours.
Slicing engine: Cura 15.04Layer Height: 0.2 mmFirst Layer Height: 0.3 mmFirst Layer Width Factor: 100 %Shell Thickness: 1.2 mmSolid Top: YesSolid Bottom: YesFill Density: 20 %Bottom/Top Thickness: 0.8 mmPrint Speed: 30 mm/sInfill Speed: 70 mm/sBottom Layer Speed: 20 mm/sSkirt Minimal Length: 300 mmSupport: EverywhereSupport Type: LinesSupport Angle: 70 °Plat. Adhesion: NoneSupport For Dual Extrusion: BothFilament Diameter: 1.75 mmFilament Flow: 100 %Print Temperature: 200 °CPrint Bed Temperature: 70 °CEnable Fan: YesMinimum Layer Cooling Time: 12 secsMinimum Cooling Feedrate: 7 mm/sEnable Retraction: YesEnable Combing: AllWipe Tower: NoOoze Shield: NoCooling Head Lift: NoInfill prints after perimeters: NoSpiral Vase: NoOnly follow mesh surface: NoNozzle Size: 0.4 mm