Gravitrax FallThrough variations
par ImShogun
Fichiers imprimables (19)
-
stl2to1_sCurveX2_Fall.stl
1 Mo · 684 téléchargements
-
stlsCurve_Fall.stl
830 Ko · 674 téléchargements
-
stl2to1_Loop_lCurve_Fall.stl
1.5 Mo · 684 téléchargements
-
stlStraight_Fall.stl
1.1 Mo · 688 téléchargements
-
stl2to1_Straight_lCurve_Fall.stl
1.2 Mo · 680 téléchargements
-
stlScurveX2_Fall.stl
1.1 Mo · 681 téléchargements
-
stlLoop_Fall.stl
1.4 Mo · 689 téléchargements
-
stlStraight_sCurve_Fall.stl
1.4 Mo · 694 téléchargements
-
stlsCurveX3_Fall.stl
1.4 Mo · 681 téléchargements
-
stl2to1_sCurveX3_Fall.stl
1.3 Mo · 677 téléchargements
-
stl2_sCurve_opposed_Fall.stl
1.1 Mo · 334 téléchargements
-
stl5to1_Loop_lCurve_Fall.stl
1.7 Mo · 336 téléchargements
-
stl4to1_Loop_lCurve_Fall.stl
1.6 Mo · 336 téléchargements
-
stlwhoopy-straigth-2sCurve-slow-falls.stl
1.4 Mo · 349 téléchargements
-
stl3to1_Loop_lCurve_Fall.stl
1.5 Mo · 339 téléchargements
-
stlspiral_to_fall.stl
1.4 Mo · 355 téléchargements
-
stl3_to_spiral_to_fall.stl
1.5 Mo · 345 téléchargements
-
stl2_to_spiral_to_fall.stl
1.5 Mo · 340 téléchargements
-
stlhex-connectorNOT-NEEDED-spare.stl
27 Ko · 355 téléchargements
Description
25/04/22: Added 7 new variations, including one with fall entrance. Added the hex connector as standalone but remeber it is already included in the tiles, so it is a spare part only.
Visit https://www.thingiverse.com/thing:4538769 to see the full collection of tiles (65+) and more instructions
DISCLAIMER: I strongly recommend buying the original Gravitrax sets. I'm only making parts that extend the great original gameplay as they cannot be found in the original set. They either add a new possibility or simplifiy/change/complete an existing one.
These tiles allow for marbles falling from higher level to fall through them. Various paths combinaisons available.
This is the first part of a growing collection of tiles on which I (re)designed from scratch (from the calliper to the end). I also adopted a new way to print the bottom hexagon that attach the tile (it is a separate print that is inside the tile and that you'll extract and then clip on. I thought it would be cool to need no supports nor a separate print :-). Hope you'll like it)
IMPORTANT: I was very careful about the measurements... I recommend to tune your printer well before printing this. And to have a look at my print settings. Else you may encounter issues with the new fixation. I only wish you get the best experience!