Two way screw
par gvera
Fichiers imprimables (7)
-
stlnut_1.stl
643 Ko · 77 907 téléchargements
-
stlnut_2.stl
644 Ko · 76 343 téléchargements
-
stltwo_way_screw.stl
2.6 Mo · 78 561 téléchargements
-
stlnut_1_shorter.stl
373 Ko · 49 482 téléchargements
-
stltwo_way_screw_long.stl
4.3 Mo · 52 052 téléchargements
-
stlnut_2_shorter.stl
374 Ko · 49 157 téléchargements
-
stlCap.stl
353 Ko · 46 340 téléchargements
Description
This is a "screw" that can thread a clockwise and counterclockwise nut. It's just satisfying to play with.
Original idea from: https://youtu.be/cDfMI5ahbJI
Edit:
Some people have asked for various variations of the screw but I haven’t had time to make most of them. I uploaded a longer screw and shorter nuts which were the easiest requests to fulfill. These are untested so print at your own risk, although they should work since I just extended or shortened the original models
There are lots of remixes that might be what you’re looking for so check them out!
Edit 2: I added a cap to seal off the open end of the bolt in case you want to trap the nuts in there. It’s really a tight fit on my well calibrated printer so keep this in mind as you print it, you may have to adjust it slightly to fit properly without it falling off.