Skulltruder
par schlem
Fichiers imprimables (5)
-
stl516skulltruder_fixed.stl
507 Ko · 4 566 téléchargements
-
stl
m8skulltruder_fixed.stl
492 Ko · 4 740 téléchargements
-
stlSAE_skulltruder__kit_spur.stl
474 Ko · 4 573 téléchargements
-
stl
4mm_stepper_drive.stl
127 Ko · 3 747 téléchargements
-
stl5mm_stepper_drive.stl
126 Ko · 3 849 téléchargements
Description
Behold and fear my Skulltruder! This is a set of spur gears for the Printrbot or any printer using Wade's accessible extruder. 13:43.
Reworked from Brook Drumm's Printrbot's involute herringbone gears, (which were ultimately derived from works by Wade and Frost) http://www.thingiverse.com/thing:16990 and Cleaned Skull by ssd (http://www.thingiverse.com/thing:4126 .
Watch one come to life:
http://www.youtube.com/watch?v=VFnkdYUqQWs
New 4mm drive gear!
ATTENTION
This work is licensed under the Creative Commons - Attribution - Non-Commercial license. This license applies only to the files and documents available for download from the Thing Files section of this Thing.
All other related content (photographs, videos, and verbiage such as contained in "Description" or "Instructions" ) are excluded from this license. with all rights reserved, unless specifically available for download This notice constitutes a clarification, not a change, to licensing for this design.