Tech Deck Obstacles
par Lock_RC
Fichiers imprimables (9)
-
stlBenchStand.stl
2 Ko · 1 055 téléchargements
-
stlRailStand.stl
3 Ko · 1 171 téléchargements
-
stl40mmBox.stl
241 Ko · 1 023 téléchargements
-
stl60mmBox.stl
263 Ko · 997 téléchargements
-
stlAngleBarForBox.stl
561 Ko · 1 002 téléchargements
-
stlFlatRail.stl
554 Ko · 1 105 téléchargements
-
stlFlatRailshort.stl
492 Ko · 1 103 téléchargements
-
stlRoundKinkedRail.stl
643 Ko · 1 080 téléchargements
-
stlBenchTop.stl
732 Ko · 1 021 téléchargements
Description
Continuing to play around with Tech Deck obstacles. My countertop is quickly turning into a skatepark. Totally unintentional, but you have to test out your prints right? I may add more depending on what comes to mind. I'll also take suggestions. Probably not going to make any quarter or half pipes though...
Glue AngleBarforBox onto box edges
Depending on your printer, the rails/bench might need to be glued into their stands.
I used drawer liner grip and glued them to the bottom of the stands and boxes using a glue stick. This is to elimnate sliding on slick surfaces and it works well. I tried grip pads, but they are thick and don't add as much grip as I would have liked.
Most things I printed at 30% infill with PLA. Going to up that a bit for the rails since they are slightly flimsy at 30%. I'm going to try 50% next. Let me know what works best for you.