Factorio Spidertron
von warmarine759
Druckbare Dateien (11)
-
stlFactorio_Spidertron_Solid.stl
30.8 Mo · 1 378 Downloads
-
stlFactorio_Spidertron_smol_leg_bolts.stl
1.1 Mo · 721 Downloads
-
stlFactorio_Spidertron_smol_leg_upright.stl
1 Mo · 692 Downloads
-
stlFactorio_Spidertron_smol_leg.stl
1.4 Mo · 686 Downloads
-
stlFactorio_Spidertron_smol_body.stl
8.6 Mo · 693 Downloads
-
stlFactorio_Spidertron_leg_Vertical_Clips.stl
1.8 Mo · 88 Downloads
-
stlFactorio_Spidertron_long_knee_Clips_clip_only.stl
590 Ko · 90 Downloads
-
3mfFactorio_Spidertron_8x_leg_Vertical_Sprews.3mf
4.6 Mo · 89 Downloads
-
stlFactorio_Spidertron_v4_base_screws.stl
8.5 Mo · 111 Downloads
-
stlFactorio_Spidertron_plastic_thigh_screw.stl
1.2 Mo · 88 Downloads
-
3mfFactorio_Spidertron_plastic_plastic_bolt.3mf
42 Ko · 88 Downloads
Beschreibung
Spidertron Spidertron does whatever a Spidertron does
Needs only a little bit of supports you should be able to print the leg parts without supports with "engineered failure" cleaning up some of the small midair print spots
No longer needs any extra parts!
tolerances are tight so please message me with your results!
I printed on a Bambu A1 mini
The long legs print vertically.
I included an 8x sprew version.
The hole in the center is for 1.75mm filament for increased strength.
Added a smaller version that should print and assemble much easier. Doesn't require any extra hardware (other than glue)
only needs supports only under the front of the legs the rest should be bridging