Cyclone Separator
by VirgilV0X
Printable files (7)
-
stlpipe_adapter.stl
39 Ko · 3 295 downloads
-
stl50_35_adapter.stl
64 Ko · 3 330 downloads
-
stlmounting_plate.stl
66 Ko · 3 353 downloads
-
stlupper_part.stl
653 Ko · 3 676 downloads
-
stlupper_part.stl
653 Ko · 4 011 downloads
-
stl
outtake.stl
138 Ko · 4 055 downloads
-
stl
lower_part.stl
329 Ko · 4 050 downloads
Description
Cyclone Separator
Print the upper part upside down with support and the lower part upright without support.
The 3rd part is the pipe for the vacuum. You don't need to print that, if you have a fitting pipe (56 mm outside diameter)
Intake and outtake are both inside 50 mm and outside 56 mm in diameter.
The whole thing is about 315 mm in height and 150 mm in diameter.
The mounting screws need to be M8. The holes are 9 mm.
The small circle on top is there to make it easier in Simplyfy3d to put the face on the bed.
If you have a wobbly lid, use the mounting plate.
Also included an adapter 50 inside to 35 inside. I just needed one - perhaps you do as well.
Put it together, seal everything and enjoy a dust free workshop :-)