Cyclone Separator

por VirgilV0X

Ficheiros imprimíveis (7)

  • stl

    pipe_adapter.stl

    39 Ko · 3 295 descargas

    Descarregar
  • stl

    50_35_adapter.stl

    64 Ko · 3 330 descargas

    Descarregar
  • stl

    mounting_plate.stl

    66 Ko · 3 353 descargas

    Descarregar
  • stl

    upper_part.stl

    653 Ko · 3 676 descargas

    Descarregar
  • stl

    upper_part.stl

    653 Ko · 4 011 descargas

    Descarregar
  • stl

    outtake.stl

    138 Ko · 4 055 descargas

    Descarregar
  • stl

    lower_part.stl

    329 Ko · 4 050 descargas

    Descarregar

Descrição

Cyclone Separator

Print the upper part upside down with support and the lower part upright without support.
The 3rd part is the pipe for the vacuum. You don't need to print that, if you have a fitting pipe (56 mm outside diameter)
Intake and outtake are both inside 50 mm and outside 56 mm in diameter.
The whole thing is about 315 mm in height and 150 mm in diameter.
The mounting screws need to be M8. The holes are 9 mm.
The small circle on top is there to make it easier in Simplyfy3d to put the face on the bed.
If you have a wobbly lid, use the mounting plate.
Also included an adapter 50 inside to 35 inside. I just needed one - perhaps you do as well.

Put it together, seal everything and enjoy a dust free workshop :-)

Etiquetas

#Cyclone #cyclone separator #cyclone vacuum #dust collector #dust commander #Shop Vac #shop vacuum