Arcade Controller BIG case
por Ferjerez
Archivos imprimibles (14)
-
stlpin.stl
164 Ko · 3 678 descargas
-
stljoystick_cover.stl
203 Ko · 3 694 descargas
-
stlright_panel.stl
875 Ko · 3 695 descargas
-
stlleft_panel.stl
876 Ko · 3 684 descargas
-
stlusb_cap.stl
436 Ko · 3 677 descargas
-
stlpin_x12.stl
1.9 Mo · 3 679 descargas
-
stl30mm_bottons_case.stl
2.9 Mo · 3 721 descargas
-
stlwires_and_24mm_buttons_cover.stl
13 Ko · 3 671 descargas
-
stlwires_and_24mm_buttons_case.stl
2.9 Mo · 3 702 descargas
-
stl30mm_buttons_plate.stl
1.2 Mo · 3 685 descargas
-
stl30mm_buttons_cover.stl
2.8 Mo · 3 713 descargas
-
stleuropean__joystick.stl
4.9 Mo · 3 734 descargas
-
stljoystick_case.stl
4.9 Mo · 3 720 descargas
-
stlpacman_joystick.stl
10.8 Mo · 3 876 descargas
Descripción
Hi!
Recently i bought an Arcade Controller Kit (http://www.ebay.es/itm/201344779838) and always wanted a big case so i designed this.
Not need much explanation. Just print an assemble.
Great for classics arcades on MAME emulator.
Only need some screws for fixing the joystick.
The modules are joined using some 'pins' and some glue. Lateral parts fits without glue. and covers for buttons and joystick just fits without glue or screws.
You have room for 6 buttons (30 mms) on top, one 30 mm button on every side (great for pinballs) and two 24 mms buttons in central module (Used for Coin and Start).
The central piece have room for the 'electronics' and i don't use any support, just put inside and conect all the wires.
Tip: Glue some EVA foam at bottom to get a good grip on table.
Tip:Use some 'cyanocrilate' based glue for PLA. Works really well.
Also has customized joystick!! I've included 2 customized joysticks for replacing the red ball: The european stick and a pac-man. Just screw on the metal bar.
Hope you enjoy it.
Have Fun!!