Arcade Controller BIG case
par Ferjerez
Fichiers imprimables (14)
-
stlpin.stl
164 Ko · 3 678 téléchargements
-
stljoystick_cover.stl
203 Ko · 3 694 téléchargements
-
stlright_panel.stl
875 Ko · 3 695 téléchargements
-
stlleft_panel.stl
876 Ko · 3 684 téléchargements
-
stlusb_cap.stl
436 Ko · 3 677 téléchargements
-
stlpin_x12.stl
1.9 Mo · 3 679 téléchargements
-
stl30mm_bottons_case.stl
2.9 Mo · 3 721 téléchargements
-
stlwires_and_24mm_buttons_cover.stl
13 Ko · 3 671 téléchargements
-
stlwires_and_24mm_buttons_case.stl
2.9 Mo · 3 702 téléchargements
-
stl30mm_buttons_plate.stl
1.2 Mo · 3 685 téléchargements
-
stl30mm_buttons_cover.stl
2.8 Mo · 3 713 téléchargements
-
stleuropean__joystick.stl
4.9 Mo · 3 734 téléchargements
-
stljoystick_case.stl
4.9 Mo · 3 720 téléchargements
-
stlpacman_joystick.stl
10.8 Mo · 3 876 téléchargements
Description
Hi!
Recently i bought an Arcade Controller Kit (http://www.ebay.es/itm/201344779838) and always wanted a big case so i designed this.
Not need much explanation. Just print an assemble.
Great for classics arcades on MAME emulator.
Only need some screws for fixing the joystick.
The modules are joined using some 'pins' and some glue. Lateral parts fits without glue. and covers for buttons and joystick just fits without glue or screws.
You have room for 6 buttons (30 mms) on top, one 30 mm button on every side (great for pinballs) and two 24 mms buttons in central module (Used for Coin and Start).
The central piece have room for the 'electronics' and i don't use any support, just put inside and conect all the wires.
Tip: Glue some EVA foam at bottom to get a good grip on table.
Tip:Use some 'cyanocrilate' based glue for PLA. Works really well.
Also has customized joystick!! I've included 2 customized joysticks for replacing the red ball: The european stick and a pac-man. Just screw on the metal bar.
Hope you enjoy it.
Have Fun!!