HexBoxStorage Interconnect
por Michaelo
Archivos imprimibles (8)
-
stlhexboxstorage.stl
494 Ko · 2 368 descargas
-
stlhexboxstoragelid.stl
265 Ko · 2 112 descargas
-
stlHexBox.stl
244 Ko · 184 descargas
-
stlHexBoxLid.stl
277 Ko · 179 descargas
-
stlhexboxreclid.stl
455 Ko · 172 descargas
-
stlhexboxrec.stl
779 Ko · 182 descargas
-
stlhexboxrec_exp_mag.stl
315 Ko · 173 descargas
-
stlhexboxrec_exp_mag_lid.stl
77 Ko · 167 descargas
Descripción
Hex Storage Box
Simple hex storage box with interconnect, includes lid option...
Height: 35mm
Width: 60mm
No test printed yet, allowed 0.2mm between fitting parts... will test later and adjust if necessary.
Print time: 1 - 2 hours depending on settings (lid ~20 minutes)...
I can't print ATM, if you print one of these can you let me know if geometry is correct, please...
By far my most popular design yet, must do more general prints, it's hearth warming to see so many likes.
Finally... fixed issue with printer settings, prints were perfect, fit like a glove. If printer is not tuned in, these boxes will not fit properly, it's kinda like a test print ;)
If you are having issues with the interconnected boxes because of tuning etc., I added a simple box and lid (same shape but not interconnected), these could glued them together to achieve the same results.
Added another storage box with interconnect and lid...
Another experimental Parts Storage Box.
Lid connects with small, low cost, 2mm magnets. Not tested yet, so don't know how it will print. Allowed 0.1mm for magnets. Will test when magnets arrive...
Mike