Knife Sharpening Guide
di DROP_DB
File stampabili (6)
-
stlslider_17_degrees.stl
24 Ko · 7 838 download
-
stlrail_foot.stl
16 Ko · 8 059 download
-
stlprop.stl
4 Ko · 7 654 download
-
stlslider_20_degrees.stl
50 Ko · 7 805 download
-
stlrail_flat.stl
16 Ko · 7 802 download
-
stlslider_15_degrees.stl
40 Ko · 5 669 download
Descrizione
This is a knife sharpening guide for 60 x 180 mm whetstones. It was inspired by this guide but is not a direct remix.
Print either the rail flat.stl or the rail foot.stl model. If your stone came with a rubber bumper, you can print rail foot.stl and the rail will slip into the bumper, which greatly helps to prevent the whole assembly from sliding around while being used. If you do not have a rubber bumper, print rail flat.stl and make due.
Print one or more of the sliders.
If your stone came unglued like mine did, giving you two separate half-height stones, then print prop.stl. This sits in the rail, and then the now-half-height stone sits in it, propping it back up to its original height.