Split flap display 11 characters
door KingKobi
Printbare bestanden (6)
-
stlrod.stl
106 Ko · 180 downloads
-
stlTurner.stl
112 Ko · 185 downloads
-
stlGear.stl
129 Ko · 178 downloads
-
stlFlap.stl
104 Ko · 181 downloads
-
stlstand.stl
97 Ko · 181 downloads
-
stlSplit_flap_round.stl
167 Ko · 182 downloads
Beschrijving
Just print everything flat (rotate in slicer), assembly is pretty straight forward. the little side hole on the stand is to put a small length of filament in to stop the gear rotating backwards, you might need to cut down the length of the inside to better fit a standard 1.75mm filament. I just used a piece of solder wire to stop extra flaps from falling, but a front face plate could also be made for that.