Up mini cooling system
door 3DO2
Printbare bestanden (7)
-
stlUP_Mini_-_clip_extra_airhose_holder.STL
80 Ko · 669 downloads
-
stlUp_mini_extruder_head_pcb_board_cover_V0_1.STL
40 Ko · 658 downloads
-
stlmain_pcb_holder_with_extra_airflow_V1_9.STL
271 Ko · 667 downloads
-
stlUP_mini_extra_side_vent_and_cooling_system_V1_1.STL
351 Ko · 673 downloads
-
stlUp_mini_extruder_head_pcb_board_cover_V0_1_GOOD.STL
38 Ko · 597 downloads
-
stlmain_pcb_holder_no_compressor_inlet_GOOD.STL
151 Ko · 598 downloads
-
stlUP_mini_extra_side_vent_casing_V1_2_GOOD.STL
161 Ko · 600 downloads
Beschrijving
This whole new extruder head design can prevent the ticking noise during PLA printing and also can prevent the overheating of the feeder motor at long term ABS prints. I designed two extra inlets as well where the secondary filament and bearing cooling is possible by compressed air.
The mod kind of effective(PLA) and also badass
(I also use a temp mod for the printer.)
Tested with ICE Black PLA and Faberdashery transparent blue PLA
A high rpm vent is advisable, to the side of the cooling case
(!!! the long term PLA prints still risky but much more better than without the mod.!!!)
extra parts that is need.
-2.5 EH CONNECTOR 3-Pin JST plug ( Male, Female, Crimps )
- 12V DC 40mm 20mm 2 Wire High rpm fan
-6 X 3 mm magnets (4 pieces) for the PCB board cover.