PS3 Controller Holder

por Graystone

Ficheiros imprimíveis (4)

  • stl

    ControllerPlate.stl

    104 Ko · 7 755 descargas

    Descarregar
  • stl

    ControllerHolderR.stl

    140 Ko · 7 682 descargas

    Descarregar
  • stl

    ControllerHolderL.stl

    140 Ko · 7 680 descargas

    Descarregar
  • stl

    ControllerHolderBottom.stl

    211 Ko · 7 701 descargas

    Descarregar

Descrição

Easy to print holder for two PS3 controllers.

Put it all together with contact glue.

Notes:

  1. You may need to sand a little bit to fit the holders into the base.

  2. Take care to have the wide part of the base plate to the rear.

  3. Note that the Controller plates go in upside down. The chamfered edge should face downwards.

Etiquetas

#PS3 #PS3 controller