PS3 Controller Holder
par Graystone
Fichiers imprimables (4)
-
stlControllerPlate.stl
104 Ko · 7 755 téléchargements
-
stlControllerHolderR.stl
140 Ko · 7 682 téléchargements
-
stlControllerHolderL.stl
140 Ko · 7 680 téléchargements
-
stlControllerHolderBottom.stl
211 Ko · 7 701 téléchargements
Description
Easy to print holder for two PS3 controllers.
Put it all together with contact glue.
Notes:
You may need to sand a little bit to fit the holders into the base.
Take care to have the wide part of the base plate to the rear.
- Note that the Controller plates go in upside down. The chamfered edge should face downwards.