Half Bridge Load Sensor mount
par minko
1 / 6
Fichiers imprimables (1)
-
stlLoad_Cell_Mount_v9.stl
73 Ko · 971 téléchargements
Description
My version of a mount for a load cell. This is a single piece mount that holds the load cell using a little flange inside the housing, so that the load cell does not fall out.
Printing:
- Layer height: 0.25mm
- Extrusion width: 0.48mm
- Walls: 4
- Top/bottom layers: 3
- Infill: 40%
A small screw (with a cap diameter less than 6.2mm) is used to attach it.
To adjust the fit you can scale the model slightly.
Assembly: https://youtu.be/HNgFiMNhTBk