Open Cable Chain
par Claghorn
Fichiers imprimables (14)
-
stlend1_fixed.stl
81 Ko · 39 914 téléchargements
-
stlCableChainEnds_fixed.stl
139 Ko · 40 099 téléchargements
-
stlend2_fixed.stl
74 Ko · 39 860 téléchargements
-
stlbarclip.stl
65 Ko · 39 556 téléchargements
-
stlend_two.stl
287 Ko · 40 302 téléchargements
-
stlCableChain.stl
322 Ko · 40 697 téléchargements
-
stlmk5_extruder_filament_guide_fixed.stl
49 Ko · 39 378 téléchargements
-
stlfilament-cap.stl
176 Ko · 39 382 téléchargements
-
stlextruder-chain-mount.stl
189 Ko · 39 467 téléchargements
-
stltop-chain-mount.stl
68 Ko · 39 471 téléchargements
-
stlspring_sixteen.stl
872 Ko · 40 754 téléchargements
-
stlnobar_sixteen.stl
1003 Ko · 41 234 téléchargements
-
stlnobar_one.stl
224 Ko · 40 936 téléchargements
-
stlspring_one.stl
172 Ko · 40 268 téléchargements
Description
A remix of http://www.thingiverse.com/thing:11978 to remove the top bar in the links and instead provide springy clips which can be easily removed and replaced to keep the cables in the chain, while still allowing them to be replaced without having to thread everything through from the end.
The files named CableChain*.stl are included here, but came from thing 11978 (though the fixed version here had to be run through the netfabb repair service).
See a dry run of a chain attached to my solidoodle at http://youtu.be/j9XkiM4_Mn4
I've also included a couple of Solidoodle specific parts for mounting the cable chain ends on the extruder and the back of the case and included a part extracted from http://www.thingiverse.com/thing:111213
The original version of this thing used bits of 1.75mm filament instead of springy clips, but it was too easy to break the filament. The springs work much better.
The long drawn out description and history of this thing can be found at http://tomhorsley.com/hardware/solidoodle/solidoodle-chain.html